23
Operations flow
The operation flow of the recorder is as follows.
z
➜
Rack mounting
Install the recorder in the rack. (Page 24)
Go to step 2 when not installing it in the rack.
x
➜
Connections
Connect the recorder to each device. (Page 26 - 33)
c
➜
Startup
Turn on the power of the recorder. (Page 40)
When using extension units, turn the power of all the extension units before
turning on the power of the recorder.
v
➜
Installation of the hard disk
drives
Install hard disk drives in the recorder. (Page 47)
When unformatted hard disk drives are installed, they will automatically be
formatted. According to your need, determine the operational mode. (Page
52 - 53)
b
➜
Network settings of the
recorder
Operate the buttons on the front panel of the recorder to configure the net-
work settings of the recorder. (Refer to the setup instructions (PDF).)
n
➜
Network settings of a PC
Change the TCP/IP setting of the PC to conform to the settings of the
recorder. (Refer to the setup instructions (PDF).)
m
➜
Formatting of the hard disk
drives
When changing the assignment of the recording areas on the hard disk
drives, display the disk configuration menu from the setup menu and format
the hard disk drives. (Refer to the setup instructions (PDF).)
,
➜
Network settings of cameras
Display the camera setup menu and configure the network settings of the
cameras. (Refer to the setup instructions (PDF).)
.
➜
Setup
Perform the required settings on the setup menu to start operation. (Refer to
the setup instructions (PDF).)
⁄0
➜
Start operation
When necessary
Replacement of the hard disk
drives
It is possible to replace or format the hard disk drives without turning off the
power of the recorder. (Page 47 - Page 55)
