Panasonic Varicam 35, Operating Manual

Page: 140 / 174

– 140 –
Chapter 11 Network Connection — Connecting the remote operation panel (AK-HRP200G)
f
Digital extender display <D.EXT>: Disabled
r
When the [MENU]
→
[CAMERA SETTINGS]
→
[Enhanced]
→
[Enhanced SW] is set to [OFF]
Following buttons are disabled in addition to limitation when [Enhanced SW] is set to [ON].
f
Matrix button <MATRIX>
f
Skin tone detail button <SKINDTL>
f
Detail off button <DTL OFF>
f
Detail volume <DTL>
f
RGain volume <GAIN R>
f
BGain volume <GAIN B>
f
RFlare/pedestal volume <FLARE/PED R>
f
BFlare/pedestal volume <FLARE/PED B>
f
Master pedestal volume <M.PED>
About adjusted value display area (4 digits)
Zoom, focus, and auto focus are not supported.
When the VFR is set to [ON], it is displayed as [
***
P] (
***
is the frame rate value).
When the VFR is set to [OFF], it is displayed as [FroF].
When the setting of the camera is set to [Native ISO] or [ISO], it is displayed as [iSo].
@ @
NOTE
t
To connect the camera and AK-HRP200G directly, use a crossover LAN cable.
t
For details, refer to the Operating Instructions of AK-HRP200G.
t
The following information is required to connect to AK-HRP200G.
-
User account name
-
Password
-
IP address
-
Port number: 49152
t
For AK-HRP200G, use Ver4.01.00 or later versions.
t
For details on the operations of ROP setup software application, refer to the Operating Instructions of AK-HRP200G.
t
For the ROP setup software application, use Ver3.0.0.0 or later versions.