Panasonic UF 890 - Panafax B/W Laser, Service Handbook

Page: 20 / 94

20
408 XMT D Transmitter received RTN after it
transmitted EOP, MPS, or EOM. Receiver receives data with error.
(Line quality is poor)
Receiver is defective.
(Modem, LCU, etc.)
FCB PCB or LCU PCB are
defective.
409 XMT D Transmitter receives PIN after it
transmitted a post message, such
as EOP, MPS, EOM, etc. Receiver receives data with error
due to poor line quality, and
receiving operator requests voice
contact.
Receiver is defective.
(Modem, LCU, etc.)
FCB PCB or LCU PCB are
defective.
410 RCV D Received DCN while waiting for
post command. (EOP, MPS, EOM,
etc.) Interface or line is faulty.
Transmitter is
defective.
411 RCV
(Polling)
B Received DCN after transmitting
NSC. Transmitter is not ready for polling
communication.
Password does not match
between transmitter and receiver.
412 G3 RX B, D No response within 12 seconds in
NSS/DCS/MPS wait state.
(After transmitting FTT) Transmitter is defective.
FCB PCB is defective.
414 RCV
(Polling)
B No response received after
transmitting 3rd NSC. Password does not match
between transmitter and receiver.
Transmitter is defective. (No
document, document jam, etc.)
415 XMT
(Polling)
B Remote side attempted to receive
message from your machine in
polling communication.
Inform the remote side that your
machine does not have the polling
transmission feature.
416 RCV D Receiver did not detect post
command, such as EOP, MPS,
EOM, etc. Transmitter is defective.Line
quality is poor. (RTC signal is
distorted due to line noise)
FCB PCB or LCU PCB are
defective.
417 RCV C Receiver returned RTN in
response to post message. Line quality is poor. (There are
excessive errors in received data)
FCB PCB or LCU PCB are
defective.
418 RCV C Receiver transmitted PIN in
response to PRI-Q from
transmitter. (Transmitting operator
requests voice contact) Line quality is poor. (There are
excessive errors in received data)
FCB PCB or LCU PCB are
defective.
420 RCV B T1 timer (35 sec.) elapsed without
detecting 300 bps signal. There is wrong incoming call.
(non-facsimile communication)
Transmitter is defective.
FCB PCB or LCU PCB is
defective.
Information Codes
Code Mode Phase Description of Problem Cause