Panasonic UF 890 - Panafax B/W Laser, Service Handbook

Page: 28 / 94

28
025 COMM. START-UP 1 = 1’st response
2 = 2’nd response Selects the communication start-up con-
dition (XMT and Polling).
(Used when Echo Suppression is dis-
abled.)
026 NON-STANDARD 1 = Off (Invalid)
2 = On (Valid) Selects own mode (Panafax mode).
027 SHORT PROTOCOL
B
1 = Off (Invalid)
2 = On (Valid) Selects the short protocol mode.
028 SHORT PROTOCOL
D
1 = Off (Invalid)
2 = On (Valid) Selects the short protocol mode.
029 REMOTE
DIAGNOSTICS
1 = Off (will not accept)
2 = On (accepts) Selects whether the machine accepts
the Remote Diagnostics from the
service station.
030 CED & 300 bps 1 = 75 ms
2 = 1 sec. Selects the pause interval between the
CED and the 300 bps signal. (Used
when Echo Suppression is disabled.)
031 RTC = EOLx12 1 = Off (EOLx6)
2 = On (EOLx12) Selects the RTC signal, EOLx6 or
EOLx12.
032 V34 TX START 2400-33600bps Selects the transmission modem start
speed in V.34 communication,
33600-2400 bps.
033 V34 RX START 2400-33600bps Selects the receiving modem start
speed in V.34 communication,
33600-2400 bps.
034 V34 TX Symbol Rate 2400-3429sr Selects the transmission symbol rate for
V.34, 3429/3200/3000/2800/2400 sr.
Press “\/“ or “/\“ to select the symbol
rate.
035 V34 RX Symbol Rate 2400-3429sr Selects receiving symbol rate for V.34,
3429/3429/3200/3000/2800/2400 sr.
Press “\/“ or “/\“ to select the symbol
rate.
036 Not Used
037 PROTOCOL DISPLAY 1 = Off (not displayed)
2 = On (displayed)
Selects whether to display the modem
speed during communication.
(Press “\/“ or “/\“ to display)
038 Not used
039 FLASH TIME 5 = 50 ms
~
100 = 1000 ms Selects the pause interval before acti-
vating the Flash key.
040 E/F TIME (Except For
U.S.A. and Canada)
5 = 50 ms
~
100 = 1000 ms Selects the pause interval before acti-
vating the Flash key.
041 PAUSE TIME 1 = 1 sec.
~
10 = 10 sec. Selects the pause interval from 1 sec. ~
10 sec. for dialing through a switchboard
or for international calls.
042 Not used
043 REDIAL INTERVAL 0 = no waiting
~
15 = 15 minutes Selects the redial interval from 0 to 15
minutes in 1 minute steps.
Function Parameter Table
No.
Parameter
(see Note 3)
Selections Function