Panasonic UF-4500, Service Manual

Page: 94 / 365

94
UF-5500 / 4500
Function Parameter Table
No. Parameter Selections Function
000 MON/TEL DIAL 1 = Monitor
2 = TEL/DIAL Selects whether the machine starts to TX automatically during
On-Hook dialing.
Monitor : Start to TX after pressing START
TEL/DIAL : Start to TX automatically
001 ALARM STATUS 1 = OFF
2 = Timer (6 sec.)
3 = Constant Selects the No Paper or No Toner alarm status.
OFF : Alarm is disabled.
Timer : Alarm will shut off after 6 seconds.
Constant : Alarm will not stop until "STOP" is pressed or the
error is cleared/corrected.
002 STOP COMM.
JRNL 1 = Off
2 = On Selects whether the machine prompts to print the COMM.
Journal when the printout condition is set to INC and STOP is
pressed during communication.
003 CONTINUOUS
POLL 1 = Off
2 = Stn (Tx only) Selects whether the Continuous Polling feature is enabled.
Stn :
Place the document(s) on the ADF then press the Program Key
[P4] to store or add the document(s) into a polled file. (See Note
4)
004 NUMERIC ID SET 1 = Off (will not accept)
2 = On (accepts) Selects whether the machine accepts and allows to set or
change the Numeric ID.
005 Not Used
006 ID DISPLAY 1 = Number (Numeric ID)
2 = Chara (Character ID)
3 = Name (Station Name)
4 = Dial (Dialing Number) Selects the priority of displaying/Printing the ID, Name or Dialing
Number. (Default : 3 = Name)
1 = Number:Number>Name>Chara>Dial
2 = Chara
: Chara>Name>Number>Dial
3 = Name : Name>Chara>Number>Dial
4 = Dial : Dial>Name>Chara>Number
007 Not Used
008 MONITOR 1 = Off
2 = On Selects whether the Monitor is ON/OFF for monitoring fax sig-
nals.
(FOR SERVICE USE ONLY)
009 DC LOOP 1 = Off (Normal)
2 = On (Off Hook) Selects a false Off Hook state for back to back communication
test.
010 TX LEVEL 00 = 0 dBm
~
15 = -15 dBm Selects the TX signal output level, 0 to -15 dBm in 1 dBm steps.
(Refer to Chapter
Information Codes (INFO. CODES)
)
011 RX LEVEL 1 = -43 dBm
2 = -38 dBm
3 = -33 dBm
4 = -48 dBm Selects the receiving sensitivity of -33/-38/-43/-48 dBm.
012 DTMF LEVEL 00 = 0 dBm
~
15 = -15 dBm Selects the DTMF output level, 0 to -15 dBm in 1 dBm steps.
013 G3 RX EQL 1 = 0 dB
2 = 4 dB
3 = 8 dB
4 = 12 dB Selects the cable equalizer for G3 reception mode, 0dB, 4dB,
8dB or 12dB.
014 G3 TX EQL 1 = 0 dB
2 = 4 dB
3 = 8 dB
4 = 12 dB Selects the cable equalizer for G3 transmission mode, 0dB, 4dB,
8dB or 12dB.
015
~
016 Not Used