Panasonic PT-LZ370E, Operating Instructions Manual

Page: 66 / 120

[PROJECTOR SETUP] menu
66 - ENGLISH
Settings
[LAMP POWER]
You can switch the electric power of projector lamp.
Set the lamp power to meet the environment and
purpose of projection.
1) Press ▲▼ to select [LAMP POWER].
2) Press ◀▶ to switch [LAMP POWER].
▶
z
The setting will change as follows each time
you press the button.
[NORMAL] [ECO]
[NORMAL] When high brightness is needed
[ECO]
When high brightness is not
needed
Note
z
The [ECO] mode can reduce power consumption
and operation noise.
z
The selection made here is reflected to the
indication of the “ECO setting level” in the “Multi
Projector Monitoring & Control Software” installed
from the supplied CD-ROM.
[LAMP RUNTIME]
You can display the lamp usage time (converted
value).
Attention
z
When replacing the lamp, follow the “Replacing the
lamp unit” (

page 102) and reset the lamp usage
time (converted value) to 0.
Note
z
When the lamp unit has reached the end of its life,
the lamp usage time (converted value) is indicated
in red and gray. Refer to “When to replace the lamp
unit” (

page 101) for details about the lifespan.
[SCHEDULE]
You can set the command execution schedule for
each day of the week.
1) Press ▲▼ to select [SCHEDULE].
2) Press ◀▶ to switch [SCHEDULE].
▶
z
The setting will change as follows each time
you press the button.
[OFF] [ON]
[OFF] Disables the set schedule.
[ON]
Enables the set schedule.
Note
z
If [SCHEDULE] is set to [ON], the setting
for [STANDBY MODE] (

page 68) in [ECO
MANAGEMENT] is automatically set to [NORMAL]
and cannot be changed. Even if [SCHEDULE] is
then set to [OFF] when in this state, the setting of
[STANDBY MODE] remains at [NORMAL].
▶ ■
How to assign a program
3) Select [ON] in Step 2), and press the
<ENTER> button.
▶
z
The [SCHEDULE] screen is displayed.
4) Select and assign program to each day
of week.
▶
z
Press ▲▼ to select the day of week, and press
◀▶ to select a program number.
▶
z
You can set the program from No.1 to No.7.
“- - -” indicates that the program number has
not been set yet.
▶ ■
How to set a program
You can set up to 16 commands to each program.
3) Select [ON] in Step 2), and press the
<ENTER> button.
4) Press
▲▼
to select [PROGRAM EDIT].
5) Press
◀▶
to select a program number
to be set ([PROGRAM 1] to [PROGRAM
7]) and press the <ENTER> button.
6) Press
▲▼
to select a command
number (01 to 16), and press the
<ENTER> button.
▶
z
You can change the page using
▲▼
.