Chapter 6
Maintenance — Light source/temperature indicators
200 - ENGLISH
Light source/temperature indicators
When an indicator lights up
If a problem should occur inside the projector, the light source indicator <LIGHT>/temperature indicator <TEMP>
will inform you by lighting or blinking. Check the status of the indicators and remedy the indicated problems as
follows.
Attention
f
Make sure to turn off the power before performing the procedure.
f
Make sure to follow the procedure in
“Turning off the projector” (
x
page 45) when switching off the projector.
f
Check the status of the power supply with the power indicator <ON (G)/STANDBY (R)>. (
x
page 41)
ON
(
G
)
/
STANDBY
(
R
)
LIGHT
TEMP
SD
Power indicator <ON (G)/STANDBY (R)>
Light source indicator <LIGHT>
Temperature indicator <TEMP>
Light source indicator <LIGHT>
Indicator status
Lighting in red
(projecting)
Blinking in red
(2 times)
Blinking in red
(3 times)
Status
The light source may not light
properly.
The light source does not light or has suddenly turned off.
Cause
―
Solution
Turn off the power supply of the interior wiring or disconnect the plug of the power cord from the outlet, and then turn
on the power again.
Note
f
If the light source indicator <LIGHT> is still lighting or blinking after taking above measures, ask your dealer for repair.