Before Use
16
ª
Using the Remote Controller
1
Direct the Remote Controller at the Remote
Control Sensor
(36)
of the Camcorder and
press an appropriate button.
≥
Distance from the Camcorder: Within
approximately 15 feet (5 meters)
≥
Angle: Within approximately 10
o
in the
upward, and 15
o
in the downward and
horizontal directions from the central axis
≥
The above operating ranges are for indoor use.
Outdoors or under strong light, the Camcorder
may not operate properly even within the above
ranges.
≥
Within a 3 feet (1 meter) range, you can also
use the Remote Controller on the LCD Monitor
side of the Camcorder.
Selecting Remote Controller Modes
When 2 Camcorders are used simultaneously,
they can be operated individually by selecting
different Remote Controller Modes.
≥
If the Remote Controller Mode of the Camcorder
and that of the Remote Controller do not match,
[REMOTE] Indication is displayed.
Setup on the Camcorder:
Set [REMOTE] on the [INITIAL] Sub-Menu to the
desired Remote Controller Mode. (
-23-
,
-24-
,
-25-
)
Setup on the Remote Controller:
[VCR1]: Press the [
D
] Button and [
∫
] Button
simultaneously.
1
[VCR2]: Press the [
E
] Button and [
∫
] Button
simultaneously.
2
≥
When the battery in the Remote Controller is
replaced, the mode is automatically reset to
[VCR1] Mode.
10˚
15˚
15˚
15˚
(36)
INDEX
INDEX
SELECT
STOP
K
L
∫
STILL ADV
W
PAUSE STILL ADV
6
1
5
;
E
D
P.B. ZOOM
2
1
Power Supply
ª
Using the AC Adaptor
1
Connect the DC Cable to the Camcorder.
2
Connect the DC Cable to the AC Adaptor.
3
Connect the AC Cable to the AC Adaptor
and the AC Jack.
≥
The AC Cable’s outlet plug does not fit
entirely into the AC Adaptor jack. A gap will
remain as shown
1
.
≥
Before connecting or disconnecting the
power supply, set the [OFF/ON] Switch on
the Camcorder to [OFF] and make sure that
[POWER] Lamp is not lit.
ª
Using the Battery
Before use, fully charge the Battery.
≥
We recommend using a Panasonic Battery.
≥
We cannot guarantee the quality of this
Camcorder when batteries from other
companies are used.
1
Attach the Battery to the AC Adaptor and
charge it.
≥
Since the Battery will not be charged when
the DC Cable is connected to the AC
Adaptor, disconnect it from the AC Adaptor.
≥
The [CHARGE] Lamp lights up, and charging
starts.
≥
When the [CHARGE] Lamp goes off,
charging is completed.
≥
When the battery is completely discharged,
the [CHARGE] lamp blinks at first, but the
battery is charged normally. When the
temperature of the battery is too high or low,
the [CHARGE] lamp blinks and the charging
time becomes longer than usual.
1
PV-GS400Eng.book 16 ページ ２００４年６月４日 金曜日 午後３時１７分
