Panasonic KX-TD1232, Program Manual

Page: 228 / 396

General Programming
228 Programming Guide
[435] DID / TIE Wink Time Out Assignment
Description
The DID / TIE outgoing method can be set to the wink mode in program [432] DID / TIE
Outgoing Assignment. This program sets the time the system waits for the confirmation wink
signal after an outside line is seized according to your central office service.
Selection
• DID / TIE format number:
1 to 8, ( =all DID / TIE formats)
• Time:
1 through 127 ( 64 milliseconds is the actual time)
Default
All DID / TIE formats — 16
Programming
1. Enter
435.
Display: 435 WINK TIMEOUT
2. Press
NEXT.
Display: Format NO?
3. Enter a
DID / TIE format number.
To enter DID / TIE format number 1, you can also press NEXT.
Display example: 1:16
4.
Enter the
time.
To change the current entry, press
CLEAR
and enter the new number.
5.
Press STORE.
6. To program another DID / TIE format, press
NEXT
or
PREV,
or
SELECT
and the desired
DID / TIE format number.
7.
Repeat steps 4 through 6.
8. Press
END.
Conditions
• You cannot leave the entry empty.
• To assign all DID / TIE formats to one selection, press the key in step 3. In this case, the
display shows the contents programmed for DID / TIE format number 1.