Panasonic KX-TD1232, Program Manual

Page: 22 / 396

General Programming Instructions
22 Programming Guide
1.5 User Programming Mode
User Programming Mode
Some programming items are accessible by any display proprietary telephone user in the
system.
The programming items are listed below:
[000] Date and Time Set
[001] System Speed Dialing Number Set
[002] System Speed Dialing Name Set
[003] Extension Number Set
[004] Extension Name Set
[005] Flexible CO Button Assignment
[006] Operator / Manager Extension Assignment
[007] DSS Console Port and Paired Telephone Assignment
[008] Absent Message
[009] Quick Dial Number Set
[012] ISDN Extension Number Set
[013] ISDN Extension Name Set
[014] VM Name Set
[017] DISA User Codes
Entering the user programming mode
You can access these programs by entering the User Programming Mode as follows:
Before entering the mode, confirm that:
• Your telephone is on-hook.
• No calls are on hold at your telephone
After entering the mode, perform the same programming steps as the system programming
steps in each program address.
Note
• If your telephone set does not have a PROGRAM button, substitute it with the PAUSE
button.
• If nothing is entered in five seconds after the PROGRAM (or PAUSE ) button is pressed,
it is canceled.
• The User Password is not shown on the display. The password can be changed by system
programming. Refer to Section [120]
User Password.
• During the programming mode, your extension is treated as a busy extension.
• Only one proprietary telephone can be in programming mode at any one time.
Press PROGRAM (or PAUSE) + + and enter the User
Password (default: 1234)