Panasonic KX-NS500, Pc Programming Manual

Page: 863 / 1064

Message Waiting Lamp
If set to "Enable", the Message Waiting Lamp of the subscriber’s telephone turns on when a new message is
recorded.
Value Range
Disable, Enable
Maintenance Console Location
20.1.2 UM Configuration—[1-2] Mailbox Settings—Full Setting—Notification Parameters
Feature Guide References
3.2.1.29 Message Waiting Notification—Lamp
Telephone Device
Specifies the Message Waiting Notification schedule for each device. The following parameters can be
specified for devices 1, 2, and 3. Click
Edit for the extension to change, set Device Notification for
Unreceived Message to "Yes", and programme the settings, then click OK to finish.
Maintenance Console Location
20.1.2 UM Configuration—[1-2] Mailbox Settings—Full Setting—Notification Parameters
Feature Guide References
3.2.1.30 Message Waiting Notification—Telephone Device
Telephone Device—Device No. 1, 2, 3—Only Urgent Messages
Specifies if notifications will be sent only for messages designated as urgent.
Value Range
Yes, No
Maintenance Console Location
20.1.2 UM Configuration—[1-2] Mailbox Settings—Full Setting—Notification Parameters
Feature Guide References
3.2.1.30 Message Waiting Notification—Telephone Device
Telephone Device—Device No. 1, 2, 3—Dial Number [0-9 * # T X , ;]
Assigns a telephone number to Device 1, 2, or 3. The subscriber can also specify the number to be dialled by
entering it from his or her telephone, allowing the subscriber to set this feature on a case by case basis.
PC Programming Manual 863
20.1.2 UM Configuration—[1-2] Mailbox Settings—Full Setting