Panasonic KX-NS500, Pc Programming Manual

Page: 355 / 1064

Feature Guide References
2.11.10 Parallelled Telephone
DPT Type—Type
Selects the port type.
To change the port type of an extension port, follow the steps below:
1.
Set the status of the extension port to "OUS".
2.
Change the port type of the extension port, then click Apply.
3.
Set the status of the extension port to "INS".
When changing the port type of an extension port for which Wireless XDP has been set on the 12.1.1 PBX
Configuration—[4-1-1] Extension—Wired Extension—Extension Settings screen, the Wireless XDP setting
must be deleted first.
When changing the type of a port for which one or more SDN buttons are set (except when changing between
PC Console and Telephone), all SDN buttons customised for that device will be deleted. When you attempt to
apply the new settings, a warning message is displayed showing the slot and port number for which SDN
buttons will be deleted. If you do not wish to delete SDN buttons for this port, click Cancel.
Value Range
Normal: For connecting a DPT or CS
DSS: For connecting a DSS Console (A maximum of 8 DSS Consoles can be connected to the PBX.)
VM (DPT): For connecting a Panasonic VPS through DPT Integration
PC Console: For connecting a PC Console (A maximum of 8 PC Consoles can be connected to the PBX.)
Maintenance Console Location
9.22 PBX Configuration—[1-1] Configuration—Slot—Extension—Port Property
Feature Guide References
2.28.1 Voice Mail (VM) Group
2.26.1 Computer Telephony Integration (CTI)
DPT Type—Location No.
Specifies the location number of the connected DSS Console or PC Console. This setting is only available
when DPT Type—Type on this screen is set to DSS or PC Console.
Note that, depending on system traffic, there may be a limit to the number of PC Consoles that can be supported
by a single DLC/DHLC card.
When changing the location number of a DSS Console for which one or more SDN buttons are set, all SDN
buttons customised for that device will be deleted. When you attempt to apply the new settings, a warning
message is displayed showing the slot and port number for which SDN buttons will be deleted. If you do not
wish to delete SDN buttons for this port, click Cancel.
Value Range
1-8
Maintenance Console Location
9.22 PBX Configuration—[1-1] Configuration—Slot—Extension—Port Property
PC Programming Manual 355
9.22 PBX Configuration—[1-1] Configuration—Slot—Extension—Port Property