10. Programmable Features
70
“
ON
”
(default): You will hear the friendly
reception voice guide, pre-recorded messages
and voice time/day stamp.
“
OFF
”
: Deactivates this feature.
Code #53: Turning SMS ON/OFF (KX-
FC235AL only)
SMS
=OFF
[
±
]
See page 41 for details.
Code #54: Changing the recording time for
your TAM/FAX greeting message
GREETING TIME
=16s
[
±
]
“
16s
”
(default): Maximum recording time is 16
seconds.
“
60s
”
: Maximum recording time is 60 seconds.
See page 61 for details.
Code #58: Setting the scan contrast
SCAN CONTRAST
=NORMAL
[
±
]
To send or copy a document with faint or dark
writing, set this feature before transmission or
copying.
“
NORMAL
”
(default): Used for normal writing.
“
LIGHT
”
: Used for dark writing.
“
DARKER
”
: Used for faint writing.
Code #67: Setting the incoming message
monitor
ICM MONITOR
=ON
[
±
]
To hear an incoming message (ICM) from the
speaker when the answering device is recording
the message.
“
ON
”
(default): You can monitor the incoming
message.
“
OFF
”
: Deactivates this feature.
Code #68: Setting the Error Correction Mode
(ECM)
ECM SELECTION
=ON
[
±
]
This feature is available when the
transmitting/receiving fax machines are ECM
compatible.
“
ON
”
(default): If there is an error during fax
transmission/reception, the fax machine will
support the communication.
“
OFF
”
: Deactivates this feature.
Note:
L
You cannot change the setting when received
documents are in memory.
Code #76: Setting the connecting tone
CONNECTING TONE
=ON
[
±
]
If you often have trouble when sending faxes,
this feature allows you to hear connecting tones:
fax tone, ring back tone and busy tone. You can
use these tones to confirm the status of the other
party’s machine.
“
ON
”
(default): You will hear connecting tones.
“
OFF
”
: Deactivates this feature.
Note:
L
If the ring back tone continues, the other
party’s machine may not be a fax machine or
may have run out of paper. Check with the
other party.
L
The connecting tone volume cannot be
adjusted.
Code #77: Changing the receiving mode in
the auto answer setting
AUTO ANSWER
=TAM/FAX
[
±
]
“
TAM/FAX
”
(default): Telephone Answering
Machine/Fax mode (page 55)
“
FAX ONLY
”
: Fax only mode (page 56)
Code #80: Resetting advanced features to
their default settings
SET DEFAULT
RESET=NO
[
±
]
To reset the advanced features:
1.
Press
{
MENU
}
.
2.
Press
{#}
, then
{
8
}{
0
}
.
3.
Press
{A}
or
{B}
repeatedly to select
“
YES
”
.
4.
Press
{
SET
}
.
5.
Press
{
SET
}
again.
6.
Press
{
MENU
}
.
Note:
L
The ECM selection (feature #68 on page 70)
will not be reset.
FC235AL-PFQX2248ZA_en.book Page 70 Monday, June 20, 2005 2:19 PM
Summary of Contents for KX-FC231NZ
Page 113: ...111 Notes ...
