12
Install the external DC power
supply near the main power
outlet, and position it in such a
way that its power plug can be
plugged into and unplugged
from the outlet easily.
When connecting the external DC power
supply to a power outlet on the ceiling or on
any other surface where dust may collect,
wipe off the dust on the power plug at
periodic intervals as an anti-tracking
measure.
If there is a possibility of noise
interference
Either wire the cables so that the power
cable (ceiling light cord) of
AC 100 V (AC 220 V) or more, and the signal
cable are placed at least 1 meter (3.3 ft.)
apart.
Alternatively run each cable through its own
metal conduit. (The metal conduits must be
grounded.)
When connecting the cables,
ensure that the connector areas
will not be subject to any load.
Doing so may cause malfunctioning.
PoE+ power supplies
Use a PoE+ [IEEE802.3at] compatible hub
or power supply device.
[Note]
The unit is connected to PoE networks
without routing to the outside plant.
Network settings
The network function of this unit does not
work unless an initial account is set up
(except when using the Easy IP Setup
Software. A personal computer is required to
set up an initial account.
[Note]
Network connection with AW-HE20 also
requires setup of an initial account. When an
initial account is not set up, AW-HE20 can
detect but cannot control this unit.