63
6.1.2.2 Operation
The SOLIRIS RTS Sensor controls and provides a measure of protection for a retractable pergola
according to the sun and wind conditions. The WIND and SUN thresholds can be adjusted by
two potentiometers, one for wind speed and the other for daylight intensity.
The adjustment range is between 10 – 50 km/h (6 – 31 mph) for the WIND and between 0 to
50 kilolux for the SUN.
By using the SOLIRIS RTS Sensor it is possible to configure the functioning of the receiver (wind
only or wind/sun). Please refer TELIS SOLIRIS RTS to the operating instructions.
A short UP/DOWN movement of the retractable pergola indicates the modification of the
sensor settings.
6.1.2.3 Single or Tandem System Connection to SUNIS (Sun) Sensor
•
IMPORTANT REMARKS BEFORE INSTALLATION
•
Expose the sensor 20min. to the daylight to initialize its autonomous system
(put the cells under the maximum daylight intensity).
•
To verify charging level of sensor, press briefly the Mode button: if LED
lights=ready for use.
•
FEATURES
•
Up to 3 sensors can be memorized in one motor, it could be combined with
other RTS sensors (EOLIS RTS, SOLIRIS RTS)
•
One Sunis sensor RTS can be memorized in several motors
•
Supply: “SOLAR”
•
Autonomy: 24 hours without new daylight intensity.
•
PROGRAMMATION
•
To proceed to programming, sensor must be charged (refer to important
remarks before installation step).
•
Enter the “Programming” Mode.
•
By pressing > 2 sec. PROG. button of Remote Control (for single motor) or
Centralis (for tandem system) until motor feedback.
•
Record a sensor.
•
By pressing briefly PROG. Button of sensor until motor feedback.
SETTING INSTRUCTIONS
LED reaction in “DEMO” mode or “USER” mode.Enter the “DEMO” mode.
Summary of Contents for SILVER PLUS
