palmiye SILVER PLUS, Installation Manual

Page: 53 / 86

53
Using a small screwdriver loosen the screws on the reverse side of the remote control and
remove the back cover.
Replace the battery with one 2430 Lithium 3V Battery.
5.5. Programming
5.5.1. Single Motor (OREA RTS) for 230VAC / 50Hz
Step 1: There isn’t any control unit box at single motor products. Therefore, you are able to
connect directly to electric power unit (230VAC / 50Hz). Notice the motor will not respond to
any transmitter until a transmitter is assigned to communicate with the motor’s receiver.
Step 2: Please select desired channel then to assign the transmitter to communicate with
the motor’s receiver, push the “UP” and “DOWN” buttons on the transmitter SIMULTANEOUSLY,
motor will jog. The OREA RTS motor records the address of this transmitter, and only this
activated transmitter can be recorded into the memory of the OREA RTS motor.
Step 3: Check direction of operation. The “UP” button must correspond to FRONT on the end-
product. In the case of a pergola, it will stretch the ceiling cover of the pergola. If the direction
is wrong, change the direction by pressing “MY” button until the motor jogs (3 seconds).
Step 4: Stop the motor at the desired BACK limit. Align the double channel fabric support
profile to the cross beam.
Step 5: To set the BACK limit, press the “MY” and “UP” buttons SIMULTANEOUSLY for more than
2 seconds. Release the buttons once the product begins to move towards front of the Pergola.
Step 6: Press “MY” button and the motor will stop.
5.4. Replacing The Battery