palmiye SILVER PLUS, Installation Manual

Page: 54 / 86

54
Step 7: Press “MY” button CONSTANTLY until motor jogs to confirm the settings (5 seconds).
Step 8: Finally, press the “PROGRAMING BUTTON” on the back of the transmitter until the
motor jogs (to leave the installation mode).
*Front limit doesn’t need to be set for Single Motor (OREA RTS) product as the motor will stop
automatically when fabric is stretch.
5.5.2. Single Motor (ALTUS 50 RTS) for 120VAC / 60Hz
Step 1: There isn’t any control unit box at single motor products. Therefore, you are able to
connect directly to electric power unit (120VAC / 60Hz). Notice the motor will not respond to
any transmitter until a transmitter is assigned to communicate with the motor’s receiver.
Step 2: Please select desired channel then to assign the transmitter to communicate with
the motor’s receiver, push the “UP” and “DOWN” buttons on the transmitter SIMULTANEOUSLY,
motor will jog. The ALTUS RTS motor records the address of this transmitter, and only this
activated transmitter can be recorded into the memory of the ALTUS motor.
Step 3: Check direction of operation. The “DOWN” button must correspond to BACK on the
end-product. In the case of a pergola, it will be closed. If the direction is wrong, change the
direction by pressing “MY” button until the motor jogs (3 seconds).
Step 4: Stop the motor at the desired BACK limit position.
Step 5: To set the BACK limit, press the “MY” and “UP” buttons SIMULTANEOUSLY for more than
2 seconds. Release the buttons once the product begins to move towards front of the pergola.
Step 6: Stop the motor at the desired FRONT limit position.
Step 7: To set the FRONT limit, press the “MY” and “DOWN” buttons SIMULTANEOUSLY for more
than 2 seconds. Release the buttons once the product begins to move towards back of the
pergola.
Step 8: Press “MY” button and the motor will stop.
Step 9: Press “MY” button CONSTANTLY until motor jogs to confirm the settings (5 seconds).