004778250 - 30/03/2020
85
ESP
AÑOL
Perfil SOLAR
En base a este perfil, es aconsejable establecer los
parámetros del ciclo de trabajo del PWM de la
siguiente manera:
PWM2
Vmín: U21 >= 15%
Vmáx: U22 <= 95%
Bajo las condiciones de Anticongelante, Seguridad y Antibloqueo, el PWM se puede configurar usando los parámetros:
➢
ANTICONGELANTE
:
U03, U13 y U23
➢
SEGURIDAD
:
U04, U14 y U24
➢
ANTIBLOQUEO
:
U05, U15 y U25
TIPO DE FLUJOSTATO
En los sistemas en los que está previsto el
Flujostato
a través del parámetro
P33
, es posible establecer el tipo:
➢
P33
= 1, gestión de entrada del Flujostato de tipo ON/OFF;
➢
P33
= 2, gestión de entrada del Flujostato mediante el uso de un sensor caudal que proporciona una señal de onda cuadrada
cuya frecuencia está en función del caudal.
En el caso de uso de un sensor de caudal (
P33
=2), se puede establecer el umbral para definir el caudal mínimo para la solicitud de agua
sanitaria utilizando el parámetro
P34
.
A continuación se muestran las conexiones para sensores
ELTEK
(código 10.0884.00.03):
GND
= terminal
16
(GND);
OUT
= terminal
15
(SEG);
IN
= terminal
18
(+V)
El sensor tiene el siguiente comportamiento de la frecuencia de la señal en función del caudal (a 30°C):
l/min
Hz
2
11,9
4
26,2
6
40
8
53,7
10
67,5
12
81,8
La elección del caudal a detectar se realiza ajustando el valor del parámetro
P34
igual al doble del valor de la frecuencia
correspondiente, por ejemplo si desea detectar un caudal superior a 2 l/min debe establecer
P34
a 24.
Si desea detectar la mínima presencia de flujo de agua en el circuito hidráulico, es recomendable ajustar
P34=5
para detectar incluso la
menor cantidad de agua.