User’s Manual
30
NOTE:
If the VGA card of a BASE system does not support the overlay function, the transmit speed can slow down
somewhat.
Use DVRNS:
Check the box to use DVRNS (DVR Name Service) server. Click the
Set up DVRNS…
button
displays the
IP Notifier – DVRNS (DVR Name Service)
dialog box allowing you to set details about DVRNS.
NOTE:
The DVRNS (DVR Name Service) allows you to connect to the DVR from remote sites using either the
dynamic IP addresses or the domain name. For the DVRNS feature to work properly, the DVR should be registered
on the DVRNS server, the DNS server should be configured during Remote – Set up network, and the DVRNS
server settings should match the settings registered on the DVRNS server. Any changes on the DVRNS server
might cause improper operation.
NOTE:
The DVRNS registration is limited to only one DVRNS server. The DVR cannot be registered to multiple
DVRNS servers.
−
DVRNS Server:
Enter the IP address (or domain name) and
port number of the DVRNS server.
−
DVR:
Enter the unit name to be registered on the DVRNS
server and enter the DVR Description. Clicking the
Check
button next to the Name box allows you to check if the
name you entered can be used. The Address displays the IP
address of the DVR. When using the NAT (Network
Address Translation) device, check the
Use NAT
box.
−
Help desk:
Displays the information registered on the
DVRNS server.
You can save your changes, register the DVR information on the DVRNS server by clicking the
Change
button,
and hide the
IP Notifier – DVRNS (DVR Name Service)
dialog box by clicking the
Hide
button.
Set up network...:
Set up the network. Refer to
Appendix 3 — Network Setup
for details.
Set up Callback…:
Set up the callback function. The DVR can be set up to notify the target server running the
SmartBase when certain events occur.
−
Use Callback:
Check the box to enable the callback function.
−
Center:
Enter the IP address of each server. A maximum of three servers
can be set.
−
Retry Counts:
Enter the number of times you would like the DVR to try
contacting the server if the connection fails.
−
When:
Select the target event. The DVR will call when the selected events
occur. Multiple selections are available. You can save your changes by
clicking the
OK
button. Selecting
Cancel
exits the
Set up Callback
dialog
box without saving the changes.
NOTE:
Callback messages will be displayed on the system status window
of the target server. They include event type, event detection time, and system
location entered during the
System
setup.
Set up
Email…:
Set up the e-mail notification. Each event can be set individually for e-mail notification. Select
the Event tab to set up.
Summary of Contents for H264
