User’s Manual
26
Setting Up the Alarm
Select an alarm:
Select an alarm icon
to set up.
NOTE:
Selecting
1-16
tab displays alarm channels to 16 and selecting
17-32
tab displays 17 to 32.
NOTE:
The alarm number indicates the Alarm Out (1 to 16/32, TTL) connector number. See
Appendix 8 —
Connector Pin Outs
for details.
Enable:
Check the box to enable the selected alarm. When selecting
Use alert sound on event
, the DVR will
play alert sound through the attached speaker during alarm output. You can set up the DVR to play different alert
sounds for each type of event. Create sound files (.wav) for each type of event under program installation folder and
name the sound files:
sensor.wav
for alarm-in,
motion.wav
for motion detection,
terror.wav
for object detection
and
vloss.wav
for video loss.
From
/
To:
Set the beginning and ending time (00:00 to 24:00) of alarm activation by holding down and dragging
the pointer.
NOTE:
In cases where the
From
hour is later than the
To
hour, the alarm will be activated at the
From
time of the
current date until next day's
To
time. If you set
To: 08:00
and
From: 18:00,
this means the alarm will be active over
night from 6:00 p.m. until 8:00 a.m. the following day.
Dwell time:
Set the alarm output duration (0 seconds to 30 minutes) by holding down and dragging the pointer.
Summary of Contents for H264
