©2016 PACE Inc., Vass, North Carolina,
All Rights Reserved
Page
5
Set up
1. Connections –
a. The TF-x800 series machines use a self-contained air pump, therefore shop air is not required.
If desired, an external pressurized Nitrogen source can be used instead.
b. Place the PC next to the machine and connect the provided USB/HDMI cables.
c. Assemble the monitor arm kit onto the right side of the TF machine, then attach monitor and
connect to PC.
d. Set out wireless keyboard and mouse, make sure they are turned on and the wireless receiver
has been plugged into the PC.
e. Plug in the power cords for the PC, Monitor, and the TF unit.
2. Accessories –
a. Insert a vacuum pick-
i. Select the smallest vacuum pick that can lift the component. If the component cannot
be reliably picked up, move to a larger vacuum pick but keep in mind this may slow
down heating of the component in relation to the surrounding area.
ii. The vacuum pick will thread into the shaft in the middle of the large circular opening on
the bottom of the heater head assembly. Never use tools to tighten the vacuum pick as
doing so can damage the threads or bend the pick.
b. Insert an appropriate nozzle-
i. Ideally, the inside of the chosen nozzle should be about 3 mm larger than the
component being worked with to allow for proper air flow. A smaller nozzle can be used
if neighboring components are too close, or the heater head can be positioned higher
above the surface during reflow. Both of these options will change the performance
and efficiency of the unit.
ii. The nozzle will attach to the ball detents in the underside of the heater head in the large
square opening surrounding the vacuum pick.
3. Power on –
a. Make sure everything is connected to an appropriate power source.
i. The 120V TF-x800 requires a dedicated 20amp circuit.
ii. The 230V TF-x800 requires a dedicated 10amp circuit.
b. Turn on circuit breaker on back of the TF machine.
c. Turn on PC and monitor.
d. Turn on the switch at the front of the machine.
e. Once PC has finished booting up and the TF machine is running, double-click on the TF-1800
software icon.
