P G . 1 0
Pacbrake is a registered trademark of Pacbrake Co.
INLINE MOUNT - FORD 6.0L
L5501
10
24
For Manual Transmissions ONLY
Connect the wires from the shifter switch to the control
unit using the butt connectors provided. Locate the white
wire of the shifter switch harness and connect it to the
Pacbrake red fused harness using the heat shrinkable butt
connector supplied. Locate the black wire of the shifter
switch harness and connect it to the white wire of the Pac-
brake control unit harness using the heat shrinkable butt
connector supplied. Connect the green wire of the shifter
switch harness to one of the factory ground locations
shown in the photo.
STEP 21 - 31 For Automatic & Manual Transmissions
25
Remove the two capscrews securing the diagnostic con-
nector to the lower dash. Locate the male/female diag
-
nostic connectors of the Pacbrake harness. Connect the
Pacbrake connector to the factory Ford connector. Using
the two capscrews removed secure the Pacbrake diag-
nostic connector to the dash. Secure the harness with the
tie-straps provided.
26
Locate the factory 4 pin connector below the steering
column, as shown in the photo. The wire in the upper
right corner should be red with a yellow trace. Check
this wire with a volt meter for 12 volts + ignition power.
Install the “T” tap connector supplied to the ignition
power source, then connect to the red fused wire of
the Pacbrake harness.
NOTE: The batteries will need to be temporarily
reconnected to locate ignition power.
