P G . 5
Pacbrake is a registered trademark of Pacbrake Co.
INLINE MOUNT - FORD 6.0L
L5501
5
8
Remove the two factory radiator support capscrews
on the passenger side and discard (see photo).
The two capscrews will be replaced with longer ones
complete with spacers.
9
Remove the vacuum pump from the factory bracket,
leaving the rubber isolators attached to the vacuum pump.
Install the vacuum pump on to the Pacbrake supplied
bracket, as show in photo.
10
Install the supplied short piece of rubber vacuum hose
onto the vacuum pump. Insert one end of the supplied
⅛" nylon hose into the rubber hose, as shown in photo.
Rubber hose marked “A”
Nylon hose marked “B”
11
Insert the two supplied M8x40 capscrews and washers
through the bracket and then the two spacers. Care-
fully insert the vacuum pump assembly onto the radiator
support brace, making sure to not kink the vacuum hose.
Torque the two capscrews into the threaded holes to 13 ft-
lbs (18 N•m). Route the ⅛" nylon hose back to the port on
the vacuum reservoir. Cut off the excess hose and install it
into the other port on the reservoir. Using the supplied tie
straps, secure the hose away from moving parts and heat
sources.
A
B
