P G . 3
Pacbrake is a registered trademark of Pacbrake Co.
INLINE MOUNT - FORD 6.0L
L5501
3
1
Disconnect the negative battery terminals on BOTH bat-
teries and then both positive battery terminals. This is to
protect the vehicles ECU from being damaged during the
installation.
EXHAUST BRAKE INSTALLATION
2
2003 Model Year Vehicles
Early production Ford trucks have a pre-cat installed in the
forward section of exhaust pipe. An alternate location for
exhaust brake installation is in the straight section of pipe
before the header pipe flange. Measure 3" forward from
the front side of the header pipe flange and mark the pipe,
then measure 6" forward from the first mark and mark the
pipe. Remove the header pipe to cut at the two marks.
The transmission cross member will need to be removed
to allow the removal of the header pipe for welding. Pro-
ceed to step 5.
3
2004 M/Y and Newer Vehicles
A 6" section of exhaust pipe must be removed to accom-
modate the exhaust brake and adapters. From below the
vehicle, measure from the front side of the header pipe
flange forward 23" and mark the pipe. Then measure and
mark the pipe 6" back from the first mark. See photo.
4
2004 M/Y and Newer Vehicles
Cut the exhaust pipe at the two marks. Cutting the pipe in
the vehicle will eliminate removing the transmission cross
member.
