x10
x10
x10
x10
20
OPERATION
8. STARTING & STOPPING
Pre-starup Checks
1. Ensure that there are no leaks in the fuel system.
2. Ensure that the safety devices and cutting attachments are complete.
3. Make sure that the harness is connected and adjusted to the correct height.
4. Ensure that there is sufficient fuel/oil mix in the tank before starting the
engine.
5. Ensure that there is sufficient bar & chain oil in the pruner chain bar oil tank
before starting the engine.
Starting the Engine when Cold
1. Set the equipment down on a hard, level surface.
2. Press the fuel pump primer bulb ten times.
3. Set the ignition switch to “ I “ ON.
4. Set the choke lever to on position “ ” (Choke On).
5. Hold the equipment securely and pull out the
starter cable until you feel it begin to resist.
Then tug sharply on the starter cable until the
engine attempts to start
