16
SETUP & PREPARATION (cont.)
Chain Lubrication
1. Place the pole pruner on a
level surface.
2. Clean the area around
the oil tank cap and then
open it.
3. Fill the chain bar oil tank with CHAIN BAR
OIL (not supplied). In doing so, make sure
that no dirt gets into the oil tank. This will
ensure that the oil nozzle does not clog.
Tank capacity 150ml.
Do not overfill.
4. Refit the oil tank cap.
5. To check the lubricating system, when
running hold it with the guide bar and
chain above some light coloured paper
such as newspaper. A steadily increasing
stain caused by oil spray shows the
lubricating system is working.
Note:
Guide bar oil may leak if the tool is left
for long periods. This is normal. If the tool is
to be left unused for an extended time, drain the oil from the tool. Refill
before use.
WARNING!
NEVER START WORK UNLESS THE CHAIN AND BAR ARE
LUBRICATED.
WARNING!
ONLY USE OIL THAT IS EXPRESSLY LABELLED “CHAIN BAR
OIL”.
