![background image](http://html.mh-extra.com/html/ozito/pmt-004/pmt-004_instruction-manual_1666603011.webp)
Lug locating hole
11
Fitting the Front Handle
1. Using the 4mm hex key, unscrew the four
socket head screws on the front handle.
2. Locate the hole on the underside of the
engine shaft as you place the lower part of
front handle in position.
3. Place the top half of the front handle on
the shaft and refit and tighten the four
socket head screws.
SETUP & PREPARATION
1. ASSEMBLY
WARNING!
DO NOT START THE ENGINE UNTIL THE UNIT IS FULLY
ASSEMBLED.
Fitting the Safety Guard
WARNING!
DO NOT OPERATE THE LINE TRIMMER/BRUSH CUTTER
ATTACHMENT WITHOUT THE SAFETY GUARD FITTED.
1. Align the underside of the line trimmer/
brush cutter shaft bracket with the safety
guard, ensuring that the two holes in the
bracket align with the holes in the safety
guard.
2. Using the 5mm hex key, fasten the two
socket head screws.
Note:
The knife edge blade on the underside
of the safety guard automatically cuts the
line to the optimum length.
3. Remove the knife edge blade cover when using the line spool before you
start working and replace it when you have finished working.