24
APPLICATIONS (cont.)
10. POLE PRUNER
Chain Lubrication
Level of oil in the oil container: Both before and during your work make sure
that there is always sufficient oil in the system. To avoid damaging the bar &
chain, never run the pruner if there is no oil in the system or if the oil drops
below the “min“ mark. On average, a single filling will last around 10 minutes
depending on the number of pauses in cutting and the loads involved.
Chain Tension
Tension of the chain, condition of the cutting elements: The sharper the
chain, the easier and more controllable it is to operate the pruner. The same
also applies to the chain tension. For greater safety you must check the chain
tension before your work and at least every 10 minutes during your work. New
chains in particular tend to expand more (see
Tensioning the Chain
.
)
Safe Working
Never stand under the branch you want to saw. Use special caution when
working with branches under tension and splintering wood.
Possible risk of injury caused by falling branches and catapulting pieces of
wood.
When the equipment is in operation, keep other persons and animals away
from the danger zone. The equipment is not protected from electric shock
through contact with high-voltage cables. Keep a minimum distance of 10m
from live cables. Electric shock can cause fatal injury. When working on slopes
always stand to the upper or left or right side of the branch you want to cut.
Hold the equipment as close as possible to your body. This will help you to keep
your balance.
Always hold the equipment firmly with both hands.
Protective clothing
Make absolutely sure to wear the appropriate, close fitting protective clothing,
such as protective pants, gloves and safety shoes. Wear hearing protection and
protective goggles a safety helmet with a face guard will provide protection
against falling and recoiling branches.
