![background image](http://html.mh-extra.com/html/ozito/asg-7000/asg-7000_instruction-manual_1666498015.webp)
7
1. Prepare 2 buckets, 1 for rinsing and 1 for waste.
2. Pour a little of the appropriate solvent (water, paint thinner,
mineral turpentine) into the waste bucket and place the
inlet hose & return pipe in. Allow as much spray material
stuck in the hoses to drip out as possible.
3. Fill the rinsing bucket with some of the solvent and
submerge the rinsed inlet hose in it.
Note:
Top up the rinsing bucket with more solvent if the inlet
filter stops being submerged. Do not allow the rinsing bucket
to run dry with the pump still running at any point in the
procedure below.
4. Ensure the priming lever is in the ‘prime’ position then
switch the unit on. Check the waste bucket and wait for a
constant stream of clear solvent to come out of the return
pipe.
Note:
The solvent in the rinsing bucket may turn cloudy from excess spray material in the
hose. Wait for the solvent coming out of the return pipe to turn the same colour, then switch off
the unit, pour the contents of the rinsing bucket into the waste bucket and repeat steps 3 & 4
until the solvent coming out of the return pipe runs clear.
4. CLEANING THE PUMP
WARNING!
THIS CLEANING PROCESS MUST BE FOLLOWED
IMMEDIATELY AFTER USE TO PREVENT PAINT FROM DRYING INSIDE
THE PUMP & HOSE. FAILURE TO FOLLOW THIS INSTRUCTION MAY
PERMANENTLY SEIZE THE PAINT SPRAYER.
RINSE
WASTE
WASTE
RINSE
WASTE
PRIME
Summary of Contents for ASG-7000
Page 24: ......