Otto Bock Avantgarde CLT, Service Manual

Page: 48 / 64

5 mm
170 171
3.13.2 Replacing the Brake Block
1) Unscrew the Allen head screw on the brake block (see fig. 171).
2) Remove/replace the brake block.
3) Tighten the screw connection with
6 Nm
.
3.13.3 Retrofitting the Wheel Lock Lever Extension
1) Remove the wheel lock handle from the knee lever wheel lock (see fig. 172). Cut open if necessary.
2) Slip the wheel lock lever extension on true to side (see fig. 173).
172 173
3.13.4 Attaching the knee-lever wheel lock for one-handed operation
1) Unfold the frame.
2) Remove the installed knee lever wheel locks on the left/right and replace with the supplied assembly (see
Page 47).
3) Engage the end of the Bowden cable in the knee lever wheel lock (see fig. 174).
4) Insert the Bowden cable through the hole in the cable attachment pin (see fig. 175).
5) Feed the Bowden cable underneath the frame to the other side (see fig. 176).
6) Slide the protective cover over the Bowden cable (see fig. 177).
7) Insert the Bowden cable through the hole in the cable attachment pin on the other side (see fig. 178).
8) Slide the spring and sleeve over the Bowden cable (see fig. 178 and see fig. 179).
9) Clamp the Bowden cable by tightening the nut (see fig. 180).
Optional:
Pull the Bowden cable further out so
that the braking effect is the same on both sides.
10) Shorten the Bowden cable to 1 cm after making the adjustments (see fig. 181).
11) Attach the cable end sleeve to the end of the Bowden cable.
48
Service Work
Avantgarde CV / CS / CLT