Otto Bock Avantgarde CLT, Service Manual

Page: 39 / 64

132 133
134 135
3.12.2.2 Installing the Fitting
INFORMATION
To set a rear wheel camber on the fitting: see Page 43.
The rear wheel can be installed at 12 height positions in the rear wheel adapter.
1) Slightly loosen the nuts on both sides of the fitting (see fig. 136, see fig. 137).
2) Pull the camber washers (selection disc for track adjustment: see fig. 138, item 1) from the interior sleeve (see
fig. 138, item 2) until the fitting can be moved.
3) Move the fitting together with the nuts, camber washers and the sleeve into the desired position.
4) Pay attention to the following when installing the fitting:
→
Slide the inner opening of each camber washer on to the teeth of the sleeve on the correct side (see
fig. 151).
→ Position the camber washer groove as parallel and upright as possible (see fig. 138, item 3).
5) Insert the spirit level holder into the groove. Insert the spirit level and align the camber washers upright (see
fig. 139).
6) Tighten the nuts on both sides of the fitting to
50 Nm
.
→ Once changed, the left and right fittings must both have the same vertical position in the rear wheel adapter.
39 Avantgarde CV / CS / CLT
Service Work