3.14 Additional options
3.14.1 Retrofitting a Lap Belt
►
Tighten the lap belt screws on the back rest tube to
7 Nm
. The lap belt mounting point is the upper free hole at
the rear part of the frame.
192
3.14.2 Retrofitting a Tray
The tray can be attached to the standard/height-adjustable desk side panel:
1) Remove the protective foil from the tray.
2) Slide the tray corresponding to the seat width onto the arm rests evenly.
3.14.3 Retrofitting a fixation kit
For using the product in vehicles for transporting persons with reduced mobility, Ottobock - in compliance with
national and international standards - has developed safety elements that improve the safety of the passengers dur
ing transport.
The installation of the fixation kit offered for the product is briefly described in the following.
3.14.3.1 Installing the 481S64=SK010 fixation kit (Avantgarde CS)
The 481S64=SK010 fixation kit is intended for installation on the Avantgarde CS.
Required tools
•
Ring spanners, sizes 10 and 13
•
Allen keys, sizes 4 and 5
Assembly
1) Attach the pipe clamps to the frame at the positions indicated (see fig. 193).
2) Screw 1 anchor plate to each of the D24 pipe clamps on the left and right of the front frame. The securement
brackets and hook symbols face outwards (see fig. 193).
3) Screw 1 anchor plate to each side of the rear frame (see fig. 194). Do not fully tighten the screws until you have
installed all pipe clamps and anchor plates and have turned them to the proper angles.
4) Screw the included pins onto the retaining plates on the left and right sides (see fig. 195, item 1).
→
The fixation kit is installed.
193
194
54
Service Work
Avantgarde CV / CS / CLT
Summary of Contents for Avantgarde CLT
Page 1: ...Service manual Avantgarde CV CS CLT...
Page 61: ...61 Avantgarde CV CS CLT...
Page 62: ...Avantgarde CV CS CLT 62...