142
143
3.12.3.2 Installing the Fitting
INFORMATION
To set a rear wheel camber on the fitting of the shock absorber: see Page 43.
The rear wheel can be installed at 3 height positions on the shock absorber.
1) Loosen the nuts on both sides of the fitting (see fig. 144, item 1).
2) Remove and change the installation position of the fitting.
3) Before tightening the fitting, position the camber washers offset from one another (for 0° wheel camber; see
fig. 144, item 2).
4) Tighten the nuts to
50 Nm
.
→
Once changed, the left and right fitting must have the same vertical position on the shock absorber.
144
3.12.4 Wheelbase extension
3.12.4.1 Retrofitting the Wheelbase Extension
1) Remove the rear wheel adapter, standard (see Page 38).
2) Move the wheelbase extension from below via the frame into position (see fig. 145).
3) Tighten the upper Allen head screw on the wheelbase extension arm from inside to
6 Nm
(see fig. 146).
4) Install the centre screw (see fig. 147):
→
Guide the Allen head screw through the centre bore on the wheelbase extension arm.
→
Insert the spacer to prevent incisions.
→
Tighten the centre screw with the aid of the hex nut to
23 Nm
.
5) Bolt down the wheelbase extension on the top rear part of the frame with size 4 Allen head screw, washer and
size 10 hex nut (see fig. 148). Torque =
23 Nm
.
6) Bolt down the wheelbase extension on the bottom rear part of the frame with size 4 Allen head screw, washer
and size 10 cap nut (see fig. 149). Torque =
23 Nm
.
7) Finally, push the protective caps onto the hex nuts (see fig. 150).
41
Avantgarde CV / CS / CLT
Service Work
Summary of Contents for Avantgarde CLT
Page 1: ...Service manual Avantgarde CV CS CLT...
Page 61: ...61 Avantgarde CV CS CLT...
Page 62: ...Avantgarde CV CS CLT 62...