79
b) "Height-adjustable" push handle
INFORMATION
When installing hand grips on the 481D64=SK040, 481D64=SK045, 481D64=SK050 and 481D64=SK055 push
handles, the adhesive may become displaced when sliding on the grip handle, resulting in the clamping bolt for
the height adjustment being glued in place. A hole must therefore be drilled in the back side of the hand grip prior
to installation.
1) Carefully cut open the old hand grip and remove material residue from the back tube.
2) Clean the tube end with solvent.
3) Drill a hole in the back side of the hand grip (481D64=ST021; 481D64=ST022) with a
Ø 2.5 mm
drill (see
fig. 80).
4) Open the adhesive packaging and follow the instructions provided by the manufacturer of the adhesive. The
manufacturer recommends using a 2-component epoxy resin adhesive or cyanoacrylate adhesive.
5) Apply the adhesive to the grip opening of each hand grip. Apply the adhesive evenly around the grip opening,
or let it spread by evenly turning the grip, up to a depth of approx.
40 to 50 mm
.
6) Turn the hand grip slightly to slide it onto the tube up to the end of the handle and position it vertically on the
wheelchair (see fig. 82). Observe the processing time.
NOTICE! Once the processing time (pot life) has expired, the adhesive is hardened and the hand grip
can no longer be moved or adjusted.
7) Allow the adhesive to harden for approx.
24 h
before handing the wheelchair over to the user.
80
81
27
Avantgarde CV / CS / CLT
Service Work
Summary of Contents for Avantgarde CLT
Page 1: ...Service manual Avantgarde CV CS CLT...
Page 61: ...61 Avantgarde CV CS CLT...
Page 62: ...Avantgarde CV CS CLT 62...
