Adjusting the angle of the pivot arm
1) Loosen and remove the Allen head screw below the pivot arm (see fig. 26, item 1). Take hold of the clamping
piece inside the tube and remove it (see fig. 26, item 2).
2) Remove the pivot arm mounting screw from the anti-tipper tube (see fig. 26, item 3).
3) Move the pivot arm to a new position (3 setting possibilities: see fig. 26, item 4).
→
The distance between the anti-tipper rollers and the ground must be max.
50 mm (2 inch)
(see fig. 25).
4) Bolt down the pivot arm.
5) Hold the clamping piece in the tube (see fig. 26, item 2). Insert the Allen head screw below the pivot arm and
screw on the clamping piece (see fig. 26, item 1).
Adjusting the length of the pivot arm
1) Press in the pushbutton on the pivot arm (see fig. 27).
2) Adjust the length of the pivot arm.
→
As a minimum, the anti-tipper rollers must project fully beyond the largest diameter of the rear wheel (see
fig. 28).
3) Allow the pushbutton on the pivot arm to engage.
max. 5 cm
25
26
27
28
3.6.4 Retrofitting the transport wheels
CAUTION
Incorrect adjustment of the transport wheels
User tipping over or falling due to installation errors
►
Align the transport wheels to the rear while installing.
►
Verify that the transport wheels have been set to the same height before using them.
1) Press the transport wheel locking pin in (see fig. 29).
2) Insert the transport wheel true to side into the vertical accessory mount.
3) Adjust the height of the transport wheels (see fig. 30). Adjust the height so that the transport wheels are
approx.
20 mm
above the ground when the rear wheel is installed.
15
Avantgarde CV / CS / CLT
Service Work
Summary of Contents for Avantgarde CLT
Page 1: ...Service manual Avantgarde CV CS CLT...
Page 61: ...61 Avantgarde CV CS CLT...
Page 62: ...Avantgarde CV CS CLT 62...