Oshkosh JLG 400S, Service And Maintenance Manual

Page: 82 / 462

SECTION 3 - CHASSIS & TURNTABLE
3-30 – JLG Lift – 3120895
18. Remove minimum angle stop (29) and servo spring
(30) from the housing.
19. Turn the housing on its side and remove the cylinder
kit assembly (31). Set the assembly aside, being
careful not to scratch the running surface.
NOTE: Grooves on the surface of the cylinder kit identify its
displacement:
20. Turn the housing over and remove the snap ring (32)
retaining the shaft seal and support washer. Remove
the support washer (33) and carefully pry out the
shaft seal (34). Discard the seal.
To avoid damaging the shaft during seal removal.
Install a large sheet metal screw into the chuck of a
slide hammer. Drive the screw into the seal surface
and use the slide hammer to pull the seal.
21. Remove the inner snap ring (35) and the shaft /
bearing assembly.
22. Remove the snap-ring (36) retaining the shaft front
bearing. Pull the bearing (37) off of the shaft (38).
Table 3-5. Displacement Identifiers
# of Grooves Frame L Frame K
1
25 38
2
30 45
3
35 - -
31
31. Cylinder Kit Assembly
Figure 3-13. Cylinder Kit
32
33
34
32. Snap Ring
33. Support Washer
34. Shaft Seal
Figure 3-14. Shaft Seal
38
37
36
35
35. Inner Snap Ring
36. Snap Ring
37. Bearing
38. Shaft
Figure 3-15. Shaft & Front Bearing