Oshkosh JLG 400S, Service And Maintenance Manual

Page: 175 / 462

SECTION 3 - CHASSIS & TURNTABLE
3120895 – JLG Lift – 3-123
Table 3-11. LPF Fuel System Diagnosis
STEP ACTION VALUE(S) YES NO
1 Were you referred to this procedure by a DTC diagnostic chart? - - Go to Step 3 Go to Step 2
2 Perform the On Board Diagnostic (OBD) System Check.
Are any DTCs present in the ECM? - - Go to the
applicable DTC Table
Go to Step 3
3 Verify that the LPG fuel tank has a minimum of 1/4 tank of fuel, that the manual
valve is open and the tank quick connect is fully engaged
Does the vehicle have fuel? - - Go to Step 4 - -
4 1. Connect a water column gauge or a manometer to the secondary test port of
the low pressure regulator (LPR).
2. Start the engine and allow it to reach operating temperature.
Does the engine start and run? - - Go to Step 5 Go to Step 8
5 With the engine idling, observe the pressure reading for the LPR secondary
pressure.
Does the fuel pressure fluctuate rhythmically OUTSIDE the specified range? -1.0" to
-2.0" w.c
Go to Step 25 Go to Step 6
6 1. Disconnect the EPR electrical connectors. NOTE: This action will cause a
DTC to be set by the ECM
2. With the engine idling observe the pressure reading on the secondary test
port.
Is the fuel pressure WITHIN the specified range? -1.0" to
-2.0" w.c
Go to Fuel Control
System Diagnosis Go to Step 7
7 1. Inspect the air intake stream between the mixer assembly and the throttle
body for leaks.
2. Inspect the fuel hose connection between the LPR and mixer assembly for
damage or leakage.
3. Inspect any vacuum hoses for leaks
Was a problem found and corrected? - - Go to Step 26 Go to Step 22
8 1. Connect a water column gauge or a manometer to the secondary test port of
the low pressure regulator (LPR).
2. Crank the engine and observe the pressure reading for the LPR secondary
pressure.
Does the fuel pressure indicate a vacuum is present? - - Go to Step 12 Go to Step 9
9 1. Remove Air induction hose to the mixer
2. Observe the air valve for movement while the engine is cranking. Note: Move-
ment of the air valve will be minimal at cranking speeds.
Does the air valve move when the engine is cranked? - - Go to Step 11 Go to Step 10
10 1. Inspect the air intake stream to the mixer assembly and the throttle body for
vacuum leaks.
2. Inspect the vacuum hoses from the mixer for proper connection and condition.
Was a problem found and repaired? - - Go to Step 26 Go to Step 24
11 Inspect the fuel hose connection between the LPR and the mixer assembly for
damage or leakage.
Was a problem found and repaired? - - Go to Step 26 Go to Step 12
12 1. Connect a 0-10 psi gauge to the primary test port of the low pressure regulator
(LPR).
2. Crank the engine and observe the pressure reading for the LPR primary pres-
sure.
Is the fuel pressure ABOVE the specified value? 1- 3 PSI Go to Step 22 Go to Step 13