Page 27
Installation and Operation Manual - Inspire 2000 Insert
The door angle can also be adjusted by unscrewing the nuts
(F)
and sliding the bracket
(G)
towards the left or the right.
F
G
Figure 19: Door angle adjustment
6.3.2 Gasket
It is important to replace the gasket with another having the same diameter and density to
maintain a good seal.
1. Remove the door and place it face-down on
something soft like a cushion of rags or a
piece of carpet.
2. Remove the old gasket from the door. Use
a screwdriver to scrape the old gasket
adhesive from the door gasket groove.
3. Apply a bead of approximately 5 mm of
high temperature silicone in the door gasket
groove. Starting from the middle, hinges
side, press the gasket into the groove.
The gasket must not be stretched during
installation.
4. Leave about ½" long of gasket when cutting
and press the end into the groove. Tuck any
loose fibers under the gasket and into the
silicone.
5. Close the door. Do not use the insert for 24
hours.
Figure 20: Door gasket
Location
Length
Dimension
Door frame
79 ½"
202 cm
Round
⅞
"
(23 mm)
www.northlineexpress.com
1-877-734-2458
