Page 18
Installation and Operation Manual - Inspire 2000 Insert
Here are three popular and effective ways to ignite wood fires.
5.2.1 Conventional Method
The conventional method to build a wood fire is to crumple
5 to 10 sheets of newspaper and place them in the firebox
and hold them in place with ten pieces of kindling wood. The
kindling should be placed on and behind the newspaper.
Then add two or three small pieces of firewood. Open the air
intake control completely and ignite the newspaper. Leave
the door slightly ajar.
Once the fire has ignited, the door can be closed with the air
control still fully open.
When the kindling is almost completely burned, standard
firewood pieces can be added.
Do not leave the insert unattended when the door is slightly open. Always close and latch the
door after the fire ignites.
5.2.2 The Top Down Method
This method is the opposite of the conventional method and only works properly if well-seasoned
wood is used.
Place three or four small, split, dry logs in the firebox. Arrange the kindling wood on the logs in
two layers at right angles and place a dozen finely split kindling on the second row. It is possible
to use ragged paper but it may not hold in place since it tends to roll while it is burning. The best
is to wrap a sheet on itself, grab the ends of the roll and make a knot. Use four or five sheets of
paper tied together and put them on top and around the kindling.
Open the air intake control completely, ignite the paper and close the door.
The down fire method has two advantages over the traditional method: first, the fire does not
collapse on itself, and it is not necessary to add wood gradually since the combustion chamber
is full before the fire is lit.
5.2.3 Two Parallel Logs Method
Two spit logs are placed in the firebox with a few sheets of twisted newspapers in between the
logs. Fine kindling is added across the two logs and some larger kindling across those, log cabin
style. Newspaper is lit.
5.2.4 Using Fire Starters
Commercial fire starters can be used instead of a newspaper. Some of these starters are made
of sawdust and wax and others are made of specialized flammable solid chemicals. Always
follow the package directions when using.
Gel starters can also be used, but only to light a fire, in a cold combustion chamber without hot
embers inside.
www.northlineexpress.com
1-877-734-2458
