Page 15
Installation and Operation Manual - Inspire 2000 Insert
− Hardwoods like oak, maple and ash can take one, or even two years to dry fully, especially if the
pieces are big;
− Firewood dries more quickly when stacked outside in a location exposed to sun and wind; it takes
much longer to dry when stacked in a wood shed;
The firewood is dry enough to burn when:
− Cracks form at the ends of logs as they dry;
− The wood turns from white or cream colored to grey or yellow;
− Two pieces of wood struck together sounds hollow;
− Dry wood is much lighter in weight than wet wood,
− The face of a fresh cut feels warm and dry;
− The moisture content read by a moisture meter is between
15% to 20%.
4. Operating the Insert
This wood heater has a manufacturer-set minimum low burn rate that must not be
altered. It is against federal regulations to alter this setting or otherwise operate this
wood heater in a manner inconsistent with operating instructions in this manual.
Before using the insert, the following steps should be followed:
• Install the faceplate (See
«Appendix 1. Faceplate Installation»
)
• Plug in the blower power cord. The sleeve
(A)
and the power cord
(B)
can be found in the owner’s
manual kit. Refer to the following figure.
B
2
3
A
1
Figure 7: Plugging in the blower power cord
The following steps are optional :
• Install the fresh air intake (See
«Appendix 2. Optional Fresh Air Intake Kit Installation»
)
• Install the refractory slabs (See
«Appendix 5. Optional Refractory Panels Installation»
)
www.northlineexpress.com
1-877-734-2458