Orolia Spectracom VelaSync 1232, User Manual

Page: 88 / 268

For more information about Holdover, see "Holdover Mode" on page 148 .
2.10.8.1 The NTP Servers and NTP Peers Panels
The NTP Servers and NTP Peers panels display which servers in the network are set up at
higher or equal Stratums (Servers or Peers, respectively), and their configurations. These
panels are also used to add, configure, or remove NTP Servers and Peers.
Note: For information on how to view NTP Clients, see "Viewing NTP Cli-
ents" on page 72 .
The NTP Servers and NTP Peers panels are part of the NTP Setup screen (see "The NTP
Setup Screen" on page 69 ), which can be accessed via MANAGEMENT > NETWORK:
NTP Setup .
Information provided in the NTP Servers and NTP Peers panels
The following columns are used to break down the status information for recognized NTP
Servers and NTP Peers .
Note: Servers will be displayed in the Status view only if they can be
resolved. They will, however, always be displayed in the Setup view in order
to reconfigure them, if necessary.
IP/HOST : Name and real-time status (color-coded)
REF ID : Identifies the type of Input REFerence e.g., GPS indicates the reference
can use GPS for its synchronization. Below is a list of potential REF IDs reported by
the VelaSync Timing System (other NTP Servers and Peers may report different ref-
erences):
76
CHAPTER
2
•
VelaSync 1232 User Manual Rev. 4
2.10 Configure NTP