Orolia Spectracom VelaSync 1232, User Manual

Page: 148 / 268

Caution: Resetting the GNSS receiver may become necessary in the rare
event of internal communication issues, and is typically ONLY required if
Spectracom Technical Support advises you to execute this command.
Note that resetting the GNSS receiver is not the same as "Deleting the GNSS Receiver
Position" below .
To reset the GNSS Receiver:
1.
Navigate to Interfaces > References: GNSS Reference
2.
Click on the GEAR button next to the GNSS Reference. The GNSS 0 window
opens:
3.
Locate the Reset Receiver box, check it, and click Submit.
3.3.3.8 Deleting the GNSS Receiver Position
The VelaSync timing system requires the exact geographic position in order to calculate
the exact system time from the GNSS signal.
The Delete Position command deletes the GNSS antenna position data that is stored in
the non-volatile memory of the GNSS receiver.
The deletion of the position data will automatically initiate a new GNSS self survey ,
provided:
a GNSS antenna is connected to VelaSync
the GNSS receiver can track at least four satellites continuously
and the GNSS receiver it is configured to operate in Standard Mode .
The objective of the GNSS Survey is to re-discover the current antenna position.
Note: A self survey will take at least 2000 seconds (33 minutes).
136
CHAPTER
3
•
VelaSync 1232 User Manual Rev. 4
3.3 Managing References