Orolia Spectracom VelaSync 1232, User Manual

Page: 84 / 268

2.10.3 Dis-/Enabling NTP
If you applied NTP configuration changes e.g., added a new NTP Server, VelaSync usually
will stop and re-start the NTP Service automatically once you clicked Submit. Changes
made to NTP configurations will also take effect after VelaSync is either rebooted or
power-cycled.
You can, however, also disable or enable the VelaSync NTP Service manually.
To disable and enable your NTP Service:
1.
Navigate to MANAGEMENT > NETWORK: NTP Setup .
2.
In the NTP Services panel, set the ON/OFF toggle switch to OFF.
3.
A notification window will confirm the status change.
4.
In the NTP Services panel, set the ON/OFF toggle switch to ON again.
Changes made will now take effect and NTP operation will be restored shortly after this
operation is performed.
2.10.4 Viewing NTP Clients
To view the NTP clients being served by VelaSync:
1.
Navigate to MANAGEMENT> NETWORK: NTP Setup .
2.
In the NTP Actions panel, click View NTP Clients :
3.
The NTP Clients window will display, showing a table of the clients that are syn-
chronizing to VelaSync via NTP:
72
CHAPTER
2
•
VelaSync 1232 User Manual Rev. 4
2.10 Configure NTP