OSHD-410H & OSHD-810 & OSHD-1610
Install & User Manual - Firmware 3.X 22
4) Turn off eSATA then connect it with DVR.
5) Turn of eSATA.
6) Turn on DVR.
2.2.4. Connecting OSN-04ST
2.2.4.1.
Connecting OSN-04ST with DVR
(1) Connect OSN-04ST with DVR using Gigabit Ethernet Cable.
(2) Connect OSN-04ST with DVR directly thru storage port of DVR.
<Note>
1) Network cable used should be Gigabit Ethernet Cable (Category-6). Otherwise connection will not be
achieved.
2) Connect OSN-04ST with DVR directly using cable. In case there is hub between DVR and OSN-04ST, we
can’t guarantee normal operation.
2.2.4.2.
Set ID setup
Use Rotary Switch to setup ID.
Different ID is required when over 2ea OSN-04ST are
connected.
Use driver to setup ID value.
100x is for ID value for unit 100, 10x for ID value for unit 10, 1x
for ID value for unit1.
ID setup value must be between 2 ~254.
e.g.) 100x=1 , 10x=2 , 1x=3 setup means ID 123 of OSN-04ST.
<Note>
1) It takes around 1 minute for connection between DVR and OSN-04ST.
4ea LED in the front will be flickering while it tries connection. They will be all on (or off, flicker) after
connection is achieved and user can check HDD list in Disk Manager menu.
2.2.5. Connecting and configuring DIO ports
2.2.5.1.
Wire handling
When connecting a wire to a terminal block, follow the instruction below. Not the different type of wire that can
be used
Standard wire: Peel off the wiring cover 8~10mm and solder it. Wire gage should AWG 22~26.
Sold wire: Peel off the wiring cover 8~10mm and solder it.Wire gage should be AWG 20~26.
