Numeric/Function Keypad Test
: This test verifies that the keypad is working correctly and as configured.
An empty table will come into view. Press any key of the keyboard to test. When pressed, each button will
appear in its corresponding box in the table displayed on the display screen. Once each button is tested,
press any button five (5) times to return to the menu.
7.1.3 Reader Menu
Press ‘3’ “ENTER” to access the
Reader Menu
. The Reader Menu allows access to configurable settings for
the card/key reader in-use by the system. The options available in the
Reader Menu
are as follows:
1. Select Reader
2. Test Readers
Select Reader
: Select the specific card reader to be used with the PV100
®
. Press “F3” to cycle through the
available options, which include Mag Reader (Track 2), Proximity Reader, Chipkey or Keyboard (no reader).
When setting this option to “Keyboard," no physical media (card, key, etc.) is required to access the system. In
this mode, it is always suggested to require a PIN entry, to disable “cards” after 3 bad PIN entries and to
invalidate unused “cards” (
"Proprietary Card File (PCF) Management" on page 41
). In keyboard mode, the
insert card message will read “Enter."
Reader Status
: This will test the functionality of the card/key reader. When prompted at the test screen,
insert or present the card or key. If the card/key reader is functioning properly, the status will be displayed as
“good” and the data on the card/key will be displayed.
Press “Clear” or “Enter," to test another card / key, or press “Enter” or “Clear” again to return to the
Reader
Menu
.
NOTE:
If Proximity Reader is selected, the system will display both the raw data read and the
converted card number that will be passed as a valid card number.
7.1.4 Tones Menu
Press ‘4’ “ENTER” to access the
Tones Menu
. The
Tones Menu
is comprised of setup and testing options
for the sound tones played by the system, including the following:
1. Tone Sequence Test
2. Keypad Tone Setup
3. Prompt Tone Setup
4. Reader Tone Setup
Tone Sequence Test
: This test verifies the tones of the PV100®. Press the number button that corresponds
with the test then press “Enter”. If functioning, a tone will be played to verify proper functionality.
Keypad/Prompt/Reader Tone setup:
1.
Tone Value
: Assigns the pitch of the tone played when a key is pressed, presented with a prompt, a
receipt is printed, or the card reader is activated/used.
2.
Tone Duration
: Defines the duration of the tone played when a key is pressed, presented with a
prompt, a receipt is printed, or the card reader is activated/used.
Doc. No.: M1900 Rev.: 8
Page 33 of 65
