optris Bottom-Up GIS 450i G7, Operator'S Manual

Page: 42 / 57

-
42
-
4 Operation
After successful hardware and software configuration and electrical installation, the operation of the system
is very simple. With the existing layout and the signal of the furnace, the system runs autonomously.
The process procedure is as follows: The glass system gets the signal from the furnace: the signal opens the
two shutters and the actual process starts. The software starts the linescan with 125 Hz and builds up the
image line by line. In the end, a complete image of the product is created and automatically saved as a
snapshot. Since each pixel is saved as a temperature value, an exact analysis can be performed afterwards.
In addition to maintaining the correct
temperature, the software also displays the
temperature distribution as a profile. Here it
can
be seen exactly how good the
temperature distribution is on the glass and
inhomogeneities can be easily detected.
Figure 24: Temperature profile vertical