optris Bottom-Up GIS 450i G7, Operator'S Manual

Page: 38 / 57

-
38
-
3.2.4 Fine tuning of the Software PIX Connect
If you want to use the area calculation of the glass surfaces via the PIX Connect software or your thermal
image of the glass is distorted, some modifications to the PIX Connect software are necessary.
Rectification of the IR image
The linescan is displayed in a metric format. The
furnace is displayed in its dimension. This means that
the length and width of the furnace must be specified in
the software. To do this, go to the menu
Tools , Line
scanner mode and select Line scanner settings . A
new window opens. Under the tab Presentation the
parameters can be entered (see Figure 20 ).
Under Width (Length of line) and Length (of scan)
the two parameters can be entered. To obtain an
undistorted representation of the product at the end of a
linescan, the
Feed rate of the furnace is still required.
This must also be entered. Then click on OK .
. Now the picture is shown undistorted.
Figure 20: Line scanner settings