optris Bottom-Up GIS 450i G7, Operator'S Manual

Page: 31 / 57

-
Installation 31
-
Figure 15: cables access
inside the shutterbox
To dismantle the cables on the shutter box, loosen the four screws on the
shutter box housing (it is not necessary to loosen the screws completely).
Remove the cover of the shutter housing by tilting it backwards and pulling
upwards. Now the end of the cable (
Figure 15 in red) can be seen on the
shutter box. Now loosen the screw for the strain relief under the cover and pull
out the slide (
Figure 15 in blue). Now you can unscrew the shutter cable and,
after laying the cable, reassemble it in the reverse order.
Now that the three main components have been successfully assembled, two
connections must be connected. The first connection is the Ethernet cable to a
computer or switch. The second connection is the power supply. The entire
system is supplied with 24 V. The power supply unit is included in the delivery.
If your machine has a power supply of 24 V DC with a current of at least 3A,
the entire system can be supplied by the machine and the power pack can be
omitted.