-
Technical Data
15
-
2.3 Optical specifications
2.3.1
Camera
Make sure that the focus of thermal channel is adjusted correctly. If necessary, focus the thermal
imaging camera with the optics (
). The turning out of the optics leads to the focus setting
"near" and the turning in of the lens to the focus setting "infinity".
Note:
The focus of the optics is set at the factory to an object distance of 90 cm (camera lens to
measurement object -
A
in
). The optics only must be focused if the distance is not
equal to 90 cm. When refocusing the optics, the shutter must also be adjusted (see
chapter
on page
Figure 4:
Focusing by turning the exterior lens ring of camera
Summary of Contents for Bottom-Up GIS 450i G7
