Appendix
Version 1.1.3 - 2020-07-21
90
Translation of the original instructions
B34H | B34HV
GB
B34H_B
34HV_
GB_
8
.f
m
10
Appendix
10.1
Copyright
This document is copyright. All derived rights are also reserved, especially those of translation,
re-printing, use of figures, broadcast, reproduction by photo-mechanical or similar means and
recording in data processing systems, neither partial nor total.
Subject to technical changes without notice.
10.2
Terminology/Glossary
10.3
Change information operating manual
Term
Explanation
Drill drift
Tool to release the bit or the drill chuck from the drill spindle
Drill chuck
Drill holding fixture
Drill head
Upper part of the geared drill
Drill sleeve
fixed hollow shaft which runs in the drill spindle.
Drilling spindle
Shaft activated by the motor
Drilling table
Supporting surface, clamping surface
Taper mandrel
Cone of the drill or of the drill chuck
Spindle sleeve lever
Manual operation for the drill feed
Quick-action drill chuck
drill holding fixture to be clamped manually.
Workpiece
part to be drilled, part to be machined.
Tool
Milling cutter, drill bit, countersink, etc.
Chapter
Short note
new version number
4.2, 4.9, 6.2
Chip filter
1.0.7
EC declaration
changed standard
1.0.8
4.9
Warning
1.0.9
CE +
Parts
EMC 2014/30/EU & LVD 2014/35/EU
Controller type V3.23 for B34HV
1.1.0
parts
Permanently lubricated plain bearings, pos. 167, 168
1.1.1
1 , 2 , parts
EMC categories , modificated drilling table
1.1.2
3
Interdepartmental transport
1.1.3
